Then, move the door toward or away from the jam until there is 1⁄ 4 inch (0.64 cm) clearance, and then retighten the screw.
For horizontal adjustment on the top track, begin by loosening the screw in the top pivot bracket. Verify that there is at least 1⁄ 4 inch (0.64 cm) clearance between the pivot door and the jam (the vertical part of the door frame that the door attaches to). Afterwards, lift the door slightly, and then drop the lower pin into the lower bracket slot. For example, place the right door's upper pivot pin into the upper-right bracket. 24 September 2021.Īttach bifold closet doors by placing the upper pivot pins into upper bracket holes. Home Improvement Specialist Expert Interview. Successfully attaching your door requires you to do this while at the same time angling the door so that the bottom of the door fits into the bottom track. Remember to make sure that the top rollers are directly above the top track's hinge when pulling the door downward. Pushing the door upward into the top track gives the door enough space to fit into the bottom track. Make sure that the top roller properly hinges itself onto the top track, and the bottom fits into the bottom track. Straighten the door by pushing the bottom part forward until it's no longer at an angle to your body, and pull the door downward. At this point, the rollers should be directly above the top track, but not hooked onto it properly. Angle the door at 15 to 30 degrees as you push it upwards. Push the top roller upwards over the top track.
0 kommentar(er)
